LOADING...

Marine Engine Treatment Instructions

TREATMENT INSTRUCTIONS

Marine Engine Treatment


Download PDF



 ***NOTE: Read through the entire instruction sheet before installing any Microlon Products.

To Install the Microlon Products-

  1. Change your oil and oil filter.

  2. Shake the Microlon containers for at least one minute.

  3. Start the engine and bring it to operating temperature. Turn the engine off and add the Engine Treatment to the crankcase, but do not exceed 20% of the total oil volume at any one time. It may be necessary to add the remaining product after the cleaners have done their job and left the engine.

  4. Change the fuel filter if possible. Add the Microlon Fuel Treatment to a 1/2 tank of fuel. The fuel treatment may be added later if needed.

  5. Immediately operate the engine for at least one hour or 100 miles. Driving is recommended, but idling is acceptable.

  6. Add the Compound 90. Drain out an amount of oil equal to the amount of Compound 90 to be added to the crankcase. Operate for 1 hour.


    ***NOTE: Do not change your oil for at least 1,000 miles after treatment to make sure that you get the full benefits of a Microlon Engine Treatment.

    ***NOTE: Microlon is compatible with all oils & fuels including synthetics.